Yes I can confirm, that 344502 is working - including doorbell suppression. But, this model has one specific issue as also described to Vasiliy. We found out, that the bus signal of the doorbell actuation is different, when the intercom inside is already active due to a doorbell ring. This may lead to misconfigurations, if the wrong signal is recorded.
Can you try a reconfiguration with FW 1.4.3 beta?
Hi Georg,
thanks for your answer. I am on FW 1.4.3 beta.
Can you share the wiring that you did for this model? If I remember correctly we have a different wiring setup than described in the config wizard.
Thanks.
I adapted the wiring. With the following, the bell from the hallway is not working anymore. Also nothing has been fixed in terms of doorbell suppression:
We then changed the wiring for the hallway doorbell, which left me with this:
The hallway doorbell is now working again. However, still no doorbell suppression and it keeps ringing 5x when doorbell suppression is activated.
Funny other bug now:
When hitting the circle button (left lower button), which activates the camera, I now get a push from Nuki that someone ringed. (EDIT: It did it a couple of times. Now that behavior is gone.)
EDIT: I know, that for the wiring on the right, the cables are upside down… This picture is from behind the bticino that shows where the BUS is. Hope that makes sense.
So in the config wizard everything worked. It turned out with this setup, nothing works outside of it. Ring to Open, manually Open, Always on mode … nothing opens the door. I am also not receiving push notifications if someone rings.
Is it save to install 1.4.4 ? Did any of you guys did tests already? @oZ1337 is experiencing some troubles, how about the rest?
Installed the 1.4.4 and re-configured the opener. Result: I am no longer able to open the door! Makes a strange noise but is obviously not able do open the door.
Thanks for the reply, I’m waiting for the next release then.
hello there, i have 2 intercoms in the building. the first one is with a camera outside the building. the second one is inside. here is the problem: when i configure the intercom from outside, only this intercom is working fine with ring to open. from the other intercom the nuki opener is not recognizing the ring. the same one is happening when i configure the other intercom from inside. when i press “ring to open” on the app, both doors are opening fine. i need to open both doors with “ring to open” from both intercoms without the app.
here is a picture of my wireing. would be great if someone could help me. tia
my wireing:
Hey,
a short update. I have tested with 1.4.6.:
- configuration works fine
- ring to open works fine (no neighbor bug)
- doorbell suppression didn’t work
Hi,
on which Version you are?
Did you ask the nuki support for the right cabeling?
Opener version is 1.4.6.
How can I reach for this support?
Thanks a lot!!
Quick question: I installed my Nuki Opener three weeks ago on a similar BTicino and it’s work well (It uses also a BTicino Bus). Today one of my neighbour says it has sometime some wild bips on his own entrance videocall device in his flat. Any chance it’s a side effect of my Nuki Opener installation ? Thanks for your answer,
Some experience with the new firmware?
Nuki Opener with BTicino Classe 100 V12B
All working without issue’s, with the cables as shown
Opener Firmware: 1.5.3
1 Like
Thanks for your Feedback. Work the doorbell suppression also?
Where did you get the graphic from?
Mine does not pass configure. The wiring is not conform the standard
Opener firmware:1.5.3 using the wiring of @Rupert
The graphic I just quickly put together with some JPEG’s and Visio. Hope it helps.