Hi! Do you have a downstairs bell button and upstairs bell button, or just one bell button!?
Hi, there is a push button for the lights and another one on the opposite side but still at the bottom to open the door, the other ones are “fake” (just empty shells made of plastic).
There are 2 bell buttons, one at the main entrance of the condo and another one next the apartment’s door.
Ok, then my workaround will not work. But have you tried the standard wiring for digital bus systems?
Well, the “standard” wiring mention the wire number 1, but my the wiring inside the Btcino starts from 3 onwards…
Thanks anyways.
Actually it should be easy to try!? The numbers on your photos you can forget, because they are for analogue configurations of this intercom, so for you have this silver sticker above the screw blocks, - where “BUS” stands means there are the “+/-” ports (sometimes “a/b”) of the bus, and the symbol means the bell-button upstairs (not downstairs, this comes over bus)! So try the standard digital bus wiring, and when it not work the first time, switch the bus and wire vice versa, and one of this two tries should be the right one, and should work!? Let me know, if you need help with the wiring!
Hi there! I have the same intercom, I tried generic-> bus (bticino) with no luck. I keep having this message in the app.
To configure the Opener, you must be in the Bluetooth range radius.
Any idea?
Hi!
I do have a problem installing with the same device, and as far as i understood in this thread, nobody postet a working solution. Can anybody help me? Thanks!!
(PS: I am not 100% Sure about the Opener Type - it might be the 334202 - because they look similar)
Sorry I don’t understand the language, - is the step for ring to open, where you should ring and the opener should automatically open the door?!
Sorry for the delay, it is the step when you try to push the button to open the door to test the setup. I always get the message “to configure the Opener, be sure to be on bluetooth’s range”.
Hi, I too have this intercom and I bought nuki opener, have you solved it in any way? Mine doesn’t work
Hi there,
I have an intercom that looks the same, can anyone help me with the wiring? Or point me to a correct answer ?
Thank you for your help
This is so frustrating! I don’t even know which model number I have (Btcino 344202 and 334202 look the same on the outside but only the latter is showing as compatible on the Nuki website)
I did the basic setup and it is working now but my main objective was the ring suppression as I have a napping baby and a dog that goes crazy when it rings. I tried the enhanced but when I’m supposed to hit the door opener the circle just keeps spinning until it times out and it tells me I need to be connected to a bridge or Bluetooth (which I am)
Both potential models seem to be compatible with the Ring intercom which I’m getting in a couple weeks, I hope that’s more successful.
But if anyone has gotten the enhanced setup working - please share your insight!
I seem to have the same model and problem. Can you also sent me a pm with insturctions
Solved! During the installation process select
Generic Bus (Generic) > bticino
When I go to the setup I manage to get to the point where I have to ring the intercom, confirm in the app en then press the open button. Nio problem until the next step, where it asks to ring the doorbell… I don’t have a doorbell with a ring smart lock. Ringing the intercom again gives a timeout. How did you pass this step?
did u find a solution?
ciao Enrico, che modello hai tu? ti funziona correttamente?
Yan you send me a photo with cableing just for opening the door please