Hello Georg,
Revisiting my Opener install and setup with the firmware 1.6.4.
I’ve wired my Opener as per the instruction with the resistor on the blue wire and connected to the plus pin. The red and purple to the D pin and the black to the malla shield as per your advice. The yellow, orange, and green are not used.
However, after selecting “Generic” and “Golmar Plus (bus)” when configuring the Opener, the setup takes me through to connect the D pin with the red and yellow wire using the wago clip, then connect the green wire to the D position.
I’ve tried all these wiring variations but I’ve not been presented the option to use the first method. Please advise.